Wire An Outdoor Motion Sensor Light – Motion Detection automatically turns the lights on when it detects movement. In case of failure, you may need to replace the lamp. It is similar to a normal light, no movement detection wiring motion sensor lights outside. Many jurisdictions and municipalities require any set to be completed by a qualified electrician lighting. Review codes specific licensing requirements before starting work.
To wire an outdoor motion sensor light turn off the switch on the main panel. Proof of existing light by turning the switch, turning on the “Test” of light and create movement. Test mode is likely that in the fixture itself. Test mode allows movement in daylight. When you are sure the circuit is disabled, remove and discard the existing accessory. Unscrew plate of the box with a screwdriver and turn the wire nuts.
12 Photos Gallery of: Wire An Outdoor Motion Sensor Light
Connect the black wire outdoor motion sensor light to the black wire sensor greenhouse. New twist on wire nuts and connect the white wire to wire sensor neutral Whitehouse. Connect the ground wire to the green house green ground screw on the device with a screwdriver. The screw can be marked “EARTH” or similar. Set the new device to the wall using screws and a screwdriver. Be careful not to pinch the cables between the fixture housing and the housing wall box. Turn on the switch and test.